With a 2 hole camshaft,the inlet side gaps are 2 at .oo4 and the other 4 @ .006.
Bearing in mind that they should all be .004 do I leave as is, or is it better to shim all to .004.
Wisdom says that they close up in service, is this correct.
Big or small
#2 Re: Big or small
If it were mine i would set them correct...... PS..can you also please give an update to your other recent post viewtopic.php?f=3&t=11611 thanks.... Steve
Steve
69 S2 2+2 (just sold) ..Realm C type replica, 1960 xk150fhc
69 S2 2+2 (just sold) ..Realm C type replica, 1960 xk150fhc
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#3 Re: Big or small
Set them correctly at 4 thou.
I can tell you from experience that an inlet set to 7 thou will be noisy.
I can tell you from experience that an inlet set to 7 thou will be noisy.
Andrew.
881824, 1E21538. 889457. 1961 4.3l Mk2. 1975 XJS. 1962 MGB
http://www.projectetype.com/index.php/the-blog.html
Adelaide, Australia
881824, 1E21538. 889457. 1961 4.3l Mk2. 1975 XJS. 1962 MGB
http://www.projectetype.com/index.php/the-blog.html
Adelaide, Australia
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#4 Re: Big or small
Thanks for all advice.
Will now set to the approved clearances.
Will now set to the approved clearances.
Link: | |
BBcode: | |
HTML: | |
Hide post links |