Hoping somebody can give me some advice regarding removal of the tailshaft housing at the back of the gearbox on a Series 1 2+2 please. Undoing the bolts will loosen the casting but despite gentle persuasion with a mallet and some more persuasive use of tyre levers the unit will not separate from the bearing on the shaft. I don’t know if this is regarded as a pig of a job or should be left to a specialist company but any advice or suggestions would be most welcome. I am West Sussex based and would take to a local specialist if anyone has any recommendations.
Many thanks
Steve
2+2 gearbox tailshaft housing
#1 2+2 gearbox tailshaft housing
Steve - 1966 2+2 1E50101 slow restoration
| Link: | |
| BBcode: | |
| HTML: | |
| Hide post links |