seat mounting problem
#1 seat mounting problem
S1 FHC RHD . We have fitted the paseinger seat fine but when we try to fit the drivers side it just will not line up with the holes in the floor. I must add it has had complete new floor pan fitted .Is there any difference in drivers ads passenger seats ?
S1 4.2 RHD Bryan
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#2 Re: seat mounting problem
Don't think so....certainly 3.8 seats have the same hole spacings on each side...I presume 4.2/seats are the same..
Julian the E-type man
1962 FHC
1966 MGB....fab little car too
1962 FHC
1966 MGB....fab little car too
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#3 Re: seat mounting problem
I had to slightly modify the mounting holes on my sliders to get the seats to fit replacement floors.
Mike
Mike
Mike - 1962 OTS 878380, 1965 Honda S600, 2001 Honda S2000
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#4 Re: seat mounting problem
Well finally fitted seats. For some reason they would only fit a certain side. Also when the runners were fitted you could see that they were not parallel with each other and we had to fit washers to level the up on both.
S1 4.2 RHD Bryan
Link: | |
BBcode: | |
HTML: | |
Hide post links |