Brake control assembly - washer question

Talk about the E-Type Series 1

Topic author
ysmalkie
Posts: 96
Joined: Fri May 16, 2014 9:11 am
Location: Poland
Poland

#1 Brake control assembly - washer question

Post by ysmalkie » Sat Jun 08, 2019 2:13 pm

I am trying to assemble the shaft and pin assembly(9) to the connecting lever(11) with the operating arm (17).

Image

The parts list lists 2 washers FW205T (5/16th" washers)
Image

Would any of you know where they go? On the upper or lower pin?


Also, There seems to be an imbalance between the 2 pins - on one side there is the nylon bush, on the other there is nothing. Is this the way it's supposed to be?

Image

Tadek
Tadek

e-type S1 3.8 FHC - in restoration phase...
Jaguar XK120 OTS
Austin-Healey 100 BN2

Link:
BBcode:
HTML:
Hide post links
Show post links


Robbiee
Posts: 238
Joined: Sun Aug 16, 2015 12:07 pm
Location: Derbyshire

#2 Re: Brake control assembly - washer question

Post by Robbiee » Wed Jun 12, 2019 9:12 am

Hi Tadek
Just had to find my pre and post photos of this part
1. There was definitely no washer between the two parts on the non nylon bush end. ..see photo... when I disassembled it
2. Second photo shows it after cleaning, plating and reconstruction
Hope this helps
Robbie
Image

Image

Image
Robbie 1962 3.8 Coupe OSG 1962 OTS ODG

Link:
BBcode:
HTML:
Hide post links
Show post links


Robbiee
Posts: 238
Joined: Sun Aug 16, 2015 12:07 pm
Location: Derbyshire

#3 Re: Brake control assembly - washer question

Post by Robbiee » Wed Jun 12, 2019 9:27 am

Hi Tadek
My rebuilt photo seems to show a washer in between the two parts ...!!. I shall check when I get home. And let you know
Robbie
Robbie 1962 3.8 Coupe OSG 1962 OTS ODG

Link:
BBcode:
HTML:
Hide post links
Show post links


Robbiee
Posts: 238
Joined: Sun Aug 16, 2015 12:07 pm
Location: Derbyshire

#4 Re: Brake control assembly - washer question

Post by Robbiee » Wed Jun 12, 2019 3:36 pm

Hi
Just checked
1. I believe the two washers are for the lower link (see my photo below)
2. There is definitely NO washer between the upper linkage despite the nylon bush lip on the Lower link means it’s not quite flat
Robbie
Image

Image
Robbie 1962 3.8 Coupe OSG 1962 OTS ODG

Link:
BBcode:
HTML:
Hide post links
Show post links


Topic author
ysmalkie
Posts: 96
Joined: Fri May 16, 2014 9:11 am
Location: Poland
Poland

#5 Re: Brake control assembly - washer question

Post by ysmalkie » Fri Jun 14, 2019 3:05 pm

Robbie,

Many thanks! I think it looks actually exactly the same as on my set.


Image

Image

Image

Image

Image

Tadek
Tadek

e-type S1 3.8 FHC - in restoration phase...
Jaguar XK120 OTS
Austin-Healey 100 BN2

Link:
BBcode:
HTML:
Hide post links
Show post links

Post Reply Previous topicNext topic