Page 1 of 1
#1 Series 1 2+2 Headlining Question
Posted: Mon Nov 11, 2019 7:26 pm
by Collfryn
Interior refit kit arrives in the next few days and I'm looking at tackling the headlining on my Series 1 2+2. Bought the car fully disassembled and looking at the parts inventory I find I'm missing BD29352 and BD29353 rear right and left headliner grippers which I will have to purchase. I'm in the dark about how and where they fit. These parts are specific to the 2+2 and all the videos and blogs I've looked at only show fitting the lining to the FHC. Has any one fitted these parts to their 2+2 and can they tell me when they go in during the headlining install. Many thanks
#2 Re: Series 1 2+2 Headlining Question
Posted: Wed Nov 13, 2019 10:02 am
by PeterCrespin
At the back, either side of the interior lamp IIRC.
Unless you still have the fragile fibre board you may find they aren’t needed when gluing sponge-backed headliner to the roof.
#3 Re: Series 1 2+2 Headlining Question
Posted: Wed Nov 13, 2019 5:23 pm
by Collfryn
Got it. Thanks Peter. Looks like these parts are out of production anyway so I'll try without.
#4 Re: Series 1 2+2 Headlining Question
Posted: Mon Jun 07, 2021 8:29 pm
by Stevejaguar
Hi, how did you get on installing your headlining? I am about to do mine. Did you use the the two toothed items that go either side of the interior light ? I have just bought a pair from Hutsons but if they are not needed I wont fit them
Steve