Hi
My trim kit from BAS came with 3 plywood panels. There are 2 for the boot floor (now installed) and a third one which seems to be for the top of the rear bulkhead. However, my car doesn't seem to have been fitted with a board on the bulkhead because the press studs for the mat are still in place from pre-rebuild and are fitted directly to the bulkhead metalwork. I didn't get any woodwork with the car when I bought it in boxes.
The board from BAS has 3.8 & 4.2 chalked on it. It doesn't appear in the spare parts catalogue so I'm happy to leave it out but wondered whether there was a view as to whether it should be there or not?
The floor contour in this area would be uneven whether it is fitted or not.
Regards
3.8 FHC Rear Bulkhead Floor Board
-
Topic author - Posts: 1648
- Joined: Thu Feb 02, 2017 12:26 pm
- Location: Shropshire
#1 3.8 FHC Rear Bulkhead Floor Board
Stuart
If you can't make it work, make it complicated!
'62 FHC - Nearing completion
'69 Daimler 420 Sovereign
'78 Land Rover Series 3 109
If you can't make it work, make it complicated!
'62 FHC - Nearing completion
'69 Daimler 420 Sovereign
'78 Land Rover Series 3 109
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#2 Re: 3.8 FHC Rear Bulkhead Floor Board
A 2+2 would have a third board but then it shouldn't say 3.8 on it.
Bob
'71 S3
'71 S3
Link: | |
BBcode: | |
HTML: | |
Hide post links |