Hi
Does anyone have a picture showing the three holes in the body to attach the bracket /prop that holds the rear hatch open on a fhc?
Forgot to drill new holes in body when the car had the rear panels and floor changed and the replacement panel does not have the holes pre drilled
FHC rear hatch support bracket
-
Topic author - Posts: 316
- Joined: Fri Apr 04, 2014 4:17 pm
- Location: Norway, Oslo
#2 Re: FHC rear hatch support bracket
Have you done it yet?
What's wrong with just using the support bracket as a template? With the other end attached to the door, find the place it sits properly and mark the holes.
What's wrong with just using the support bracket as a template? With the other end attached to the door, find the place it sits properly and mark the holes.
Jerome Lunt
1970 S2 FHC - Dark Blue, Red Interior, MX5 Seats
2008 MX-5 NC PRHT
1970 S2 FHC - Dark Blue, Red Interior, MX5 Seats
2008 MX-5 NC PRHT
Link: | |
BBcode: | |
HTML: | |
Hide post links |
-
Topic author - Posts: 316
- Joined: Fri Apr 04, 2014 4:17 pm
- Location: Norway, Oslo
#3 Re: FHC rear hatch support bracket
Have not done it yet.
I suppose that will work, but the support is angled and I guess there is a sweet spot were it should be attached to the body. So that the hatch doesnt open too much or too little
I suppose that will work, but the support is angled and I guess there is a sweet spot were it should be attached to the body. So that the hatch doesnt open too much or too little
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#4 Re: FHC rear hatch support bracket
Does this help?
The mount bracket is 7 inch from the centre of the boot hatch.
Jerry
The mount bracket is 7 inch from the centre of the boot hatch.
Jerry
Jerome Lunt
1970 S2 FHC - Dark Blue, Red Interior, MX5 Seats
2008 MX-5 NC PRHT
1970 S2 FHC - Dark Blue, Red Interior, MX5 Seats
2008 MX-5 NC PRHT
Link: | |
BBcode: | |
HTML: | |
Hide post links |