Page 1 of 1
#1 New member
Posted: Thu Dec 12, 2019 8:17 am
by Harry the Polisher
Great to be part of your E type forum .
You may have seen my name mentioned on a cam polishing post .
It’s what I do in my little workshop located in deepest Derbyshire.
These have just been finished for a client , polishing by me and Vapourblasting work by Ben at vapourworx ..
Again thank you
Harry
#2 Re: New member
Posted: Thu Dec 12, 2019 8:56 am
by chrisfell
Ooooooo! Polished ally porn. The only kind.
#3 Re: New member
Posted: Thu Dec 12, 2019 5:00 pm
by AshM
Nice to see you on here H.
The master at his craft...
#4 Re: New member
Posted: Fri Dec 13, 2019 4:37 am
by MarkRado
Harry,
looks fabulous! How about posting some prices for typical polishing work, eg cam cover, inlet manifold (3.8/4.2), carb dome, in the "for sale" section?
#5 Re: New member
Posted: Mon Dec 16, 2019 9:16 pm
by SEJohnson95
Hi Harry
Welcome to the forum - I’ve seen your work on various Facebook groups, and it’s always been very impressive.
Nice to hear from a fellow Derbyshireman too - when I’m not doing my PhD, I’m straight back home to my favourite place, I love Derbyshire.
Keep an eye out for Derbyshire events as my friend and I do a few each year. You’d be more than welcome along.
Cheers
Simon
#6 Re: New member
Posted: Sun Jan 05, 2020 5:35 pm
by GravyGraham
I’ve been admiring your handiwork on Facebook for some time.
#7 Re: New member
Posted: Wed Mar 04, 2020 1:33 am
by showone
I am also a new member , and I am happy to see that there are people that have the same rare medical condition that I have..... A.A.P.D. " Acute Aluminum Polishing Disorder " .
Love your work. I will try to post some of my polishing work on my v12 engine , when I learn to use this forum.
John.