Recently bought the aluminium kit from sgn Barrett and to be honest is a very good replacement, however! It has become evident that I may not have the original centre dash.
When I bought the car someone had covered the aluminium in black vinyl, horrible! So I removed it to find 1000's of scratches etc... So left the centre dash until now.
It seems that the previous owner must of swapped the centre dash for a later one covered in black vinyl... I have obviously gone to fit the new aluminium over this but there seems to be a lip at the top of the aluminium so it won't sit flush with the centre dash... Question is do I cut the lip off the brass console or the aluminium sheet. I don't really want a sharp edge at the top of the Alu but don't know the best way to cut the brass.
Any one have a picture of the original series 1 centre dash pulled down so I can compare?? Was there two different centre dashes?
Series 1 aluminium centre dash replacement
#2
Not really sure what you are asking for but I have this out and enclose a picture of it. Let me know if I can be of further help.
Restauration project of a serie 1 1963 model OTS now running proudly
| Link: | |
| BBcode: | |
| HTML: | |
| Hide post links |
#4
Like that?
Restauration project of a serie 1 1963 model OTS now running proudly
| Link: | |
| BBcode: | |
| HTML: | |
| Hide post links |