Page 1 of 1
#1 Front lower fulcrum shaft
Posted: Sun Jan 15, 2017 5:41 pm
by dal2.0litrefrogeye
Hi . I've noticed the front lower fulcrum shaft is slightly (1/2 ") longer at one end on the wishbone landing area to the opposed end on the same shaft ,both shafts are like this . I assume you put it together so when all three pieces are together the wishbone to end of thread are equal at both ends .
Hope that made sense ish
Cheers for any ideas
Darren
#2 Re: Front lower fulcrum shaft
Posted: Sun Jan 15, 2017 6:22 pm
by 288gto
Just for you Darren....
Simon
#3 Re: Front lower fulcrum shaft
Posted: Sun Jan 15, 2017 6:33 pm
by mgcjag
Hi Darren....as Simon shows...you do have the extre washer on the long side to fit...part 32 here
http://www.sngbarratt.com/CatalogueProd ... 052&a=4052
#4 Re: Front lower fulcrum shaft
Posted: Sun Jan 15, 2017 8:16 pm
by dal2.0litrefrogeye
Hi cheers for replies , and photo , hi yes im lucky enough to have my wifes one here to copy various parts from , but when i noticed the two different lengths it got me wondering ? And as it goes i couldnt find any mention of the importance of it anywhere? ..,, yonks ago i was told this by someone
"A stupid question is one thats not asked " .... gawd knows who it was though
