The 'E' Type Forum

Hi,
I’ve just fitted the stone and mud guards along with the rubber seals/strips.
On the left handed side, where should the shorter bonnet valance rubber seal ‘mate’ with the mudshield rubber?
Mine wants to squeeze down the forward face of the mudshield rubber seal as below:



However, this has made the bonnet difficult to shut and the gap between rear bonnet edge and bulkhead has increased.
I have trimmed the valance seal down 5mm which has helped the closing, but the bulkhead gap is still too wide.

Should the valance seal mate on the forward edge of the mudshield seal, or on to the riveted seal strip?

Tia

Don’t worry, think I’ve sussed the problem.
Way too embarrassed to say what it was though.

Come on, you’re amongst friends here !
We could start a new thread “ daft things I’ve done but dare not declare”

Crikey - I’ve come out in a cold sweat !