The 'E' Type Forum

Posted: **Wed Feb 29, 2012 11:10 am**

Hello,
I'm rebuilding an xk engine for my 68 series 1.5 FHC but not sure how to install the distributor drive shaft at the correct angle. Can anyone please provide a definite instruction?
Double thank you,
Graham

Posted: **Thu Mar 08, 2012 12:23 pm**

Hello again,
I've installed the distributor drive and checked position by trial fitting the distributor with the rotor arm lined up to the no 6 piston spark plug on the dizzy cap. that should do it!
Regards
Graham

The 'E' Type Forum

engine rebuild Distributor drive shaft installation ?!!

#1 engine rebuild Distributor drive shaft installation ?!!

#2 update