Page 1 of 1
#1 3.8 FHC door seals
Posted: Fri Apr 04, 2014 9:54 am
by keith Portsmore
3.8 FHC door seals. I am about to replace these seals which are past their sell by. Have any of you chaps attempted this and do you have any useful tips. Ant comment gratefully received.
#2
Posted: Fri Apr 04, 2014 1:57 pm
by christopher storey
Keith : it is not easy. It really cannot be done properly unless you take the doors off, as the front vertical seal has to be glued into the channel created by the riveted shield which follows the cross-sectional curve of the door