original profile interior

[Charles BLANCHET]

I am currently restoring a serie 1 e type fhc 1963 and at the moment, i am having trouble finding
the original profile interior trim in tehe picture below.

I was hoping that someone can point me to the right direction.

kind regards.



Charles BLANCHET

[mgcjag]

Hi Charles if your refering to the chrome part i think these are unavailable....some have had good results useing the chrome bonnet trim that runs between front wing and center panel...Steve

[Simonpfhc]

Hi Charles,

If those pictures are your actual car, then they look quite usable. They are quite easy to remove once the whole trim piece has been removed - drill out the rivets locating them behind the trim and very carefully lever them off. I did this on mine and they cleaned up like new and where pretty easy to re-fit.

Cheers.

[Polse7317]

+1

[Charles BLANCHET]

Dear guys,
thank you so much for you reply.
that s not picture of my car , and i have to find those parts because
My car didn t have them when i bought it.
Kind regards.

Charles

[ysmalkie]

Hi,

They are exactly the same profile as the BD19029/1 bonnet trim, which is available from SNG, for example. You just have to bend them to shape.

Bonet trim: BD19029/1 - 53"

The so called Finisher Bead comes in 3 pieces in 3 lengths on the later S1 cars:
BD24414 - 51" - above the windows.
BD20191/2* - 21" - in the rear.
BD23508/9* - 4.5" - below the rear side window.

This means that 3x BD19029/1 would do for a rear window beading for the S1 FHC.

Tadek