Page 1 of 1
#1 original profile interior
Posted: Tue Jul 17, 2018 8:41 am
by Charles BLANCHET
I am currently restoring a serie 1 e type fhc 1963 and at the moment, i am having trouble finding
the original profile interior trim in tehe picture below.
I was hoping that someone can point me to the right direction.
kind regards.
Charles BLANCHET
#2 Re: original profile interior
Posted: Tue Jul 17, 2018 9:08 am
by mgcjag
Hi Charles if your refering to the chrome part i think these are unavailable....some have had good results useing the chrome bonnet trim that runs between front wing and center panel...Steve
#3 Re: original profile interior
Posted: Tue Jul 17, 2018 9:20 am
by Simonpfhc
Hi Charles,
If those pictures are your actual car, then they look quite usable. They are quite easy to remove once the whole trim piece has been removed - drill out the rivets locating them behind the trim and very carefully lever them off. I did this on mine and they cleaned up like new and where pretty easy to re-fit.
Cheers.
#4 Re: original profile interior
Posted: Tue Jul 17, 2018 2:26 pm
by Polse7317
+1
#5 Re: original profile interior
Posted: Wed Jul 18, 2018 8:19 am
by Charles BLANCHET
Dear guys,
thank you so much for you reply.
that s not picture of my car , and i have to find those parts because
My car didn t have them when i bought it.
Kind regards.
Charles
#6 Re: original profile interior
Posted: Wed Jul 18, 2018 4:44 pm
by ysmalkie
Hi,
They are exactly the same profile as the BD19029/1 bonnet trim, which is available from SNG, for example. You just have to bend them to shape.
Bonet trim: BD19029/1 - 53"
The so called Finisher Bead comes in 3 pieces in 3 lengths on the later S1 cars:
BD24414 - 51" - above the windows.
BD20191/2* - 21" - in the rear.
BD23508/9* - 4.5" - below the rear side window.
This means that 3x BD19029/1 would do for a rear window beading for the S1 FHC.
Tadek