Page 1 of 1
#1 Thackery Washer #10 - location?
Posted: Tue May 07, 2024 4:03 pm
by ysmalkie
I am finishing up my s1 FHC and found a Thackery Washer #10 that came with the car - it was probably loose.
1/4" Thackery Washer is used on the battery clamps, however is there any place where this smaller #10 goes?
I have no idea on it's PN.
Tadek
#2 Re: Thackery Washer #10 - location?
Posted: Tue May 07, 2024 4:13 pm
by dxke38
Hi Tadec, the only one I can think of is on the throttle linkage pivot pin, it stops the link rattling.
#3 Re: Thackery Washer #10 - location?
Posted: Tue May 07, 2024 4:14 pm
by mgcjag
Hi Tadek..see similar posts below. One on clutch slave pin and throttle linkage..Steve
#4 Re: Thackery Washer #10 - location?
Posted: Tue May 07, 2024 7:49 pm
by ysmalkie
Hi,
Many thanks - you mean this one - no 11 on the drawing?
Tadek
dxke38 wrote: ↑Tue May 07, 2024 4:13 pm
Hi Tadec, the only one I can think of is on the throttle linkage pivot pin, it stops the link rattling.
#5 Re: Thackery Washer #10 - location?
Posted: Fri May 10, 2024 9:06 am
by dxke38
Sorry for delay Tadec, yes thats the one. It goes on the spindle first then the fulcram then flat washer and splitpin.
#6 Re: Thackery Washer #10 - location?
Posted: Fri May 10, 2024 10:00 am
by ysmalkie
Many thanks!