The 'E' Type Forum

Folks,
Been looking at the 'sticky' for the original 3.8s on the site. The FHC featured has its rear floor mat in two pieces , a rectangle and an 'L' shaped piece. Mine is in one piece, which is supposed to roll out of the way to allow access to the spare wheel etc . but proves to be tight and awkward!

Are they both correct or is mine wrong?
Thanks,
David

David : my very early 4.2 is the same as the 3.8 and it has a one-piece mat with a slit along the rear edge of the spare wheel well so that that section can be unbuttoned and folded to the left without disturbing the parts which cover the fuel tank area and the rear axle area . I agree with you that the dimensions are such that it is difficult to get the board out without unfastening some of the other studs

Hi Christopher,

Difficult is one word for it!

David