#1 Bonnet heater inlet duct - changeover point
Posted: Thu Oct 24, 2013 7:14 pm
There appear to be two types of heater inlet duct fitted to S1 cars (the fibre glass duct which directs air from the bonnet into the heater)
I think the earlier type has a larger base which fits up against the inner wing, while the later type has a much smaller base area.
Can anyone advise at what point this change in duct was introduced ?
Chris
I think the earlier type has a larger base which fits up against the inner wing, while the later type has a much smaller base area.
Can anyone advise at what point this change in duct was introduced ?
Chris