The 'E' Type Forum

I found at the bottom my chrome parts basket that part.... ? I don't remember were it goes ? an idea ?

Ikea ?

Carsten

Looks like an air compressor fitting perhaps ?

Durango2k wrote:Ikea ?

Carsten

Unlikely Carsten , if it was Ikea , he would have a lot more parts left over and the tone of his question post would be much more angry/frustrated.

Simon

Did you check if it is metric thead ?
But really it don't seem to be a car bolt.
Mich

My guess? Some sort of pressure restrictor.
Not an E Type part.

It looks like some kind of a bleeder or lubrication fitting. Is the screw inside actually threaded into it, or has it just become trapped in there during transport?

It certainly doesn't seem to be a Jaguar part like I've ever seen.

If the threads are imperial, and the screw actually seals the port, look closely at your cooling, fuel, PAS, and other hydraulic systems for a suitable threaded hole. Somebody may have fitted it as a bleed point, on the Reservac tank, for example. It may also just have been used to plug an oil, coolant, or vacuum port on the engine.

Looks like an adaptor that you would use with an mechanical oil pressure guage, that replaces one of the oil galley plugs in the block.
The interior screw perhaps to seal it if the gage is not fitted??

Paul

The thread is a metric one..... so i think this part went in the basket when i was looking out !!!!

Probably the end of this mystery ...