Speedo cable routing
-
Topic author - Posts: 262
- Joined: Thu Jun 30, 2016 9:53 pm
#1 Speedo cable routing
Would anyone have a photo helping to show the (assumed) 'correct' exit point through the bulkhead and subsequent route for the speedo cable? I understand there is going to be variation in the route due to a variety of other factors (such as cable length), but I want to make sure it at least has started from the correct hole. This is all for a RHD. Currently it has been put back flapping around over the airbox inlet rear trumpet to the carbs, and I know it needs to be underneath that somewhere.
Richard
- 1969 Series 2 OTS, family owned 40+ years
- 1969 Series 2 OTS, family owned 40+ years
Link: | |
BBcode: | |
HTML: | |
Hide post links |