rear bumper seal fitting

[rolando38]

I've sent the whole afternoon trying to settle the position of the rear bumper as it happened to be missing the 2 big bolts under each rear light...
I'm not 100% pleased with the result, althuogh I used washers to lower the horizontal central part; it's still a little bit higher than the lateral parts



I had to glue the rubber, though , I could see no way of just inserting it
but the main question remains for me: how does the end of the rubber finish ? I hope I dod'nt cut it too short

[mgcjag]

Hi Ronaldo....have a look at this link, although its on a S3, however my S2 2+2 is about the same but but fitted a bit sharper around the tight bend... Steve viewtopic.php?t=7441

[rolando38]

thanks mgcjag !
I'll try to bend it this way (sharp bend but maybe needs cutting

[mgcjag]

Hi Ronaldo this may help:

[r.ludeke]

I put on the smaller size from a ser one.I know it is not original but it looks better i think and bends much easier around the corner at the end.