Hi all i have series 1 1/2 e type that i am converting to R/H/D the car was stripped when i bought it and the original wire loom was cut up some what, so i ordered from SNG a main loom ,engine loom & alternator loom. The car is series 1 body but series 2 dash etc all was going well until i fitted the alternator loom. all fitted well in engine bay but its to short to reach the ignition on drivers side without extending it ,id hoped it would fit without doing this SNG have said its the right one. anyone got any idears ,any pics of a R/H/D dash area and ignition area would be a great help as this is holding my build up .i also have 1 thick brown wire near fuses that im not sure were it goes any positive feedback will be much appreciated car is 1968
Thanks in advance