The 'E' Type Forum

Restoring a series 3 Roadster and need lots of panels
I have ordered quite a few from Martin Robey, but being series 3 they don't do as many as the other models

In particular in chasing centre tunnel rear section and the rear inner wing chassis sections that go to the floor as well as panels that weld to the floor were back seat would go
any tips ideas greatly appreciated

Cheer John

John,
unfortunately the E-type community does not have a Chuck (Monocouque Metalworks) for the series 3. Chuck makes the best replacement panels for series 1. If your panel is the same as a series 1, he will be able to make a 100% perfect replacement piece for your car.
http://www.monocoque-metalworks.com/main/

Cheers ......... Ole

I have contacted Chuck at present he is not doong series 3 hopefully in the future he will