The 'E' Type Forum

Hi,

I have managed to get hold of a rotisserie to enable me to work on my S3. I am looking to make some brackets to get the rotisserie to fit my car but need to know if any of you good folks have any pictures of where to mount it to the back end? I have had a few suggestions, but believe a picture tells a thousand words.

Here's a whole BBQ, with Rotisserie, mounted on the back of a car. Does this help?

Nice one Malcolm.

More like this though?

Ha Ha good one Malcolm.

Wow James, that's a feat of engineering - you must need a degree in architecture to build that?

Not sure my amateur welding skills can stretch to something as complicated as that.

Hi.....worth looking here.....possibly cheaper than making your own...also call to see how they mount...Steve https://www.rolloverjigs.com/product/jaguar-e-type-jig/

Hi Steve,

Thanks for the link. However I already have the rotisserie. I am just having difficulty seeing where to mount it onto the rear end of the car.

Hi Davie
I'm assuming the rear end of an S3 is not a lot different to an S2? If this is the case then these pics of the rear rotisserie mounting on my S2 might help?
ATB
Andy

Hi Andy,

Those pics are really helpful.

Thanks very much.

Hi Dave,

This is how I made the one on mine. With the front I utilised the front Picture frame as the frames were rusted. and the rear I attached to the Rear to the Middle bar mounts and drilled 2 extra holes to mount the lower bracket.






Cheers John