Which way round does the windscreen sealing rubber fit,on a roadster?,Or shall I just stand under a cold shower?
Which Way Round
#1 Which Way Round
69 S2 2+2
07 Vanquish S
07 Vantage Roadster
65 Austin Healey 3000
66 Scimitar Coupe
He who dies with the most toys wins.
07 Vanquish S
07 Vantage Roadster
65 Austin Healey 3000
66 Scimitar Coupe
He who dies with the most toys wins.
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#2 Re: Which Way Round
Id'ing the sides in yr photo: 12, 2, 3, 6 and 9 o'clock.
3 o'clock is the top. 9 o'clock is the bottom (sits on the windscreen), 6 o'clock is facing backwards, 12 oclock is facing forwards. You are holding the LH end.
3 o'clock is the top. 9 o'clock is the bottom (sits on the windscreen), 6 o'clock is facing backwards, 12 oclock is facing forwards. You are holding the LH end.
Regards,
ColinL
'72 OTS manual V12
ColinL
'72 OTS manual V12
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#3 Re: Which Way Round
Thank you.I will try that.
69 S2 2+2
07 Vanquish S
07 Vantage Roadster
65 Austin Healey 3000
66 Scimitar Coupe
He who dies with the most toys wins.
07 Vanquish S
07 Vantage Roadster
65 Austin Healey 3000
66 Scimitar Coupe
He who dies with the most toys wins.
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#4 Re: Which Way Round
Im interested to know how you plan to attach the seal into the channel. Which adhesive and which sides?
I have just replaced my seal and not convinced I have this correct.
I have just replaced my seal and not convinced I have this correct.
Teddington UK. Series 3 OTS 1972. Owned since 1982.
Link: | |
BBcode: | |
HTML: | |
Hide post links |
-
- Posts: 21
- Joined: Fri Dec 20, 2019 8:57 pm
- Location: USVI
#5 Re: Which Way Round
Stand under the shower, 1 minute for each of those venerable vehicles you own.
Link: | |
BBcode: | |
HTML: | |
Hide post links |
#6 Re: Which Way Round
Yup, more toys u have, more cold showers you'll need. Its the showers that will get you, I think its one of the laws of natural deselection. For my part I didn't use any adhesive, I found after a couple of uses it was worked in there snugly. If I was going to use adhesive it would be the top edge only, and I would have the hood tightened down hard while the adhesive was setting.
Regards,
ColinL
'72 OTS manual V12
ColinL
'72 OTS manual V12
Link: | |
BBcode: | |
HTML: | |
Hide post links |