Ecrou de roue bloqu?....Can't go out the whell

christophe37 · Post by **christophe37** » Sat Oct 24, 2015 7:52 pm

Hi,

I have a problem to remove the whell (with 1 screw in the center)

Solutions ?

Regards,

Je n'arrive pas ? d?monter l'?crou central sur une de mes roues (?crou central sur roue ? rayon).
J'ai tap?, chauff?, mis du d?grippant.....sans succ?s ....

Des id?es ?

Amities,

Christophe

Sjmmarsh · Post by **Sjmmarsh** » Sun Oct 25, 2015 9:41 am

Christophe

It sounds like the spinner isn't moving. Are you using the brass fitting that goes over the spinner and the Thor hammer ?

I found that I had to hit it VERY hard to get it to move, but eventually it started to move a millimetre at a time.

You have to be brave if it is a rear wheel as the wing is in the way!

Steve

Post by **mgcjag** » Sun Oct 25, 2015 11:07 am

Hi Christopher. ...look at the arrow to make sure you are undoing in the correct direction

christophe37 · Post by **christophe37** » Mon Oct 26, 2015 7:38 pm

Hi,

Thanks for youre answers.

I use the brass system but now it's ko.

I buy a new for make a new test (i round in the good late).

Next step in few days...

Thanks a lot

Link:
BBcode:
HTML:
	Hide post links

Link:
BBcode:
HTML:
	Hide post links

Link:
BBcode:
HTML:
	Hide post links

Link:
BBcode:
HTML:
	Hide post links

The 'E' Type Forum

Ecrou de roue bloqu?....Can't go out the whell

#1 Ecrou de roue bloqu?....Can't go out the whell

#2

#3

#4