The 'E' Type Forum

Hi,

I have a problem to remove the whell (with 1 screw in the center)

Solutions ?

Regards,


Je n'arrive pas ? d?monter l'?crou central sur une de mes roues (?crou central sur roue ? rayon).
J'ai tap?, chauff?, mis du d?grippant.....sans succ?s ....

Des id?es ?

Amities,

Christophe

Christophe

It sounds like the spinner isn't moving. Are you using the brass fitting that goes over the spinner and the Thor hammer ?

I found that I had to hit it VERY hard to get it to move, but eventually it started to move a millimetre at a time.

You have to be brave if it is a rear wheel as the wing is in the way!

Steve

Hi Christopher. ...look at the arrow to make sure you are undoing in the correct direction

Hi,

Thanks for youre answers.

I use the brass system but now it's ko.

I buy a new for make a new test (i round in the good late).

Next step in few days...

Thanks a lot