Bell housing to 4.2 engine block technical drawing

[Rich70]

Hi all.

Does anyone have a technical drawing of the bolt pattern that mates the gearbox bell housing to the 4.2 engine block?

I’m hoping someone can save me a few hours of work as I’ll have to split my setup to take the measurements.

Thank you in advance.

R

[mgcjag]

Hi Rich....there is this drawing in the service manual but with no dimensions....i dont know of one with all tne measurements.....if your after a few dimensions then members may be able to measure for you it tbey have an engine, bell houseing thats out....Steve

[mgcjag]

Hi Rich......i have a 4.2 auto bellhouseing on the bench i could take measurements from if it helps.....Steve

[Rich70]

Hi Steve,

I would be most grateful if you could do that for me.

I’m not sure if you could place the housing on a scanner or photocopier? If it’s copied in sections I could then stitch the images together, in an ‘actual size’ resolution, and work from the template to build a model in CAD.

Once I have a technical drawing and assured the measurements I’ll post it here for future members.

R

[mgcjag]

Hi Rich....how about i do a pencil rubbing on to paper then post to you?.....pm me your name and address. ....Steve

[JerryL770]

Once I have a technical drawing and assured the measurements I’ll post it here for future members.

R

I will be very interested to get copy of your final drawing. Would be much appreciated thank you.

After that, I would need a drawing of the gearbox to bell housing face, location of the primary shaft and length of the bell housing.

[mgcjag]

Hi Jerry.....put up a seperate post.....someone may have that info and post it....im just sending auto bell to engine info.....Steve