Rear roof lining grippers and interior light

phoenix · Post by **phoenix** » Sat May 13, 2023 9:08 am

Hi. How do I attach the two roof lining grippers which seem to have 4 0r 5 very small holes. I have found corresponding holes on the bodywork but they a quite a bit bigger. ( grippers new) Screws or pop rivets . Screws I would think myself.
Next is there another interior light somewhere near the drivers side B pillar .
Also should I put sound deadening felt under the Hardura of the seats.
S1 4.2 RHD FHC.
Thanks guys actually getting there close to finishing it has been an enjoyable (mostly) adventure building one from bare shell and not having taken it apart .

DWW · Post by **DWW** » Sat May 13, 2023 12:32 pm

There is only one interior light should be fitted center rear.

Series1 Stu · Post by **Series1 Stu** » Sat May 13, 2023 9:53 pm

Pop rivets, not screws. I think they are 3/32" diameter.

Regards

Polse7317 · Post by **Polse7317** » Sat May 20, 2023 11:49 am

If i can help with that Photo....! i used screws....

Link:
BBcode:
HTML:
	Hide post links

Link:
BBcode:
HTML:
	Hide post links

Link:
BBcode:
HTML:
	Hide post links

Link:
BBcode:
HTML:
	Hide post links

The 'E' Type Forum

Rear roof lining grippers and interior light

#1 Rear roof lining grippers and interior light

#2 Re: Rear roof lining grippers and interior light

#3 Re: Rear roof lining grippers and interior light

#4 Re: Rear roof lining grippers and interior light