@DWW
Our bonnet is slightly displaced in the locking area. This makes locking it a bit fiddly. The car had front damage and the bonnet needed to be repaired. But it didn't work out 100 percent.
New door skins also had to be installed and then adjusting the gap dimensions was a nightmare.
We have also improved the cooling system. I know someone whose E-Type had an engine failure in the 70s due to overheating. So that was right on the list.
But the new windshield was a real nightmare. It's an early 1962. Shortly after the end of the flat floor.
When installing the new windshield, it turned out that it didn't want to sit properly in the rubber. You could see through in between. Then the windshield broke. So bought a new windshield. But exactly the same problem here. Instead of trying to do it with force, they now fixed the windshield in the rubber with sealant.
I once read that apparently the 1961 and early 1962 had a slightly different shaped windshield. This is no longer available and owners of such E-Types should take good care of their original windshield so that it doesn't break and have to be replaced. I have no idea if there's anything to it. But in our case it looked like the windshield wasn't quite the right size.
The braking system is currently giving us a headache.
New brake cylinders. New brake booster. New brake calipers. So we didn't expect any brake problems.
First it started with the brake staying closed after a few times and not opening again.
Then they tried around with it and suddenly it worked again. But after a few hours the same problem was there again.
They then readjusted the brakes in another workshop and it actually worked quite well. But we have now suddenly lost a massive amount of braking power.
If you drive faster than 50mph you risk your life.
So he soon goes back to the workshop.
However, we will then convert to 4-piston aluminum with internally ventilated discs.
A few days ago I replaced the heat shield behind the brake fluid reservoirs with a new one. To do this I had to pull the reservoirs forward a little.
The next day there was a puddle under the car. Brake fluid.
I then saw that a hose clamp was sitting too low at the bottom of the reservoir. But I couldn't move it all the way up and tighten it. The hose may be broken or the drain nipple on the container is broken (are the original reservoirs). Now we will order new reservoirs and have them installed when he goes back to the workshop because of the brake problem.
You fix one problem and two new ones arise. It's been like this for a year now.
But someday, sometime...
