Plug chop after run

Technical advice Q&A
User avatar

Topic author
abowie
Posts: 4149
Joined: Wed Sep 07, 2011 9:15 pm
Location: Australia
Australia

#1 Plug chop after run

Post by abowie » Sun Apr 20, 2014 3:13 am

Nice run today.

What are people's opinions on the tune of the car?

http://www.projectetype.com/images/4.2_ ... 4_2014.jpg
Andrew.
881824, 1E21538. 889457. 1961 4.3l Mk2. 1975 XJS. 1979 MGB (supercharged).
Adelaide, Australia

Link:
BBcode:
HTML:
Hide post links
Show post links


christopher storey
Posts: 5698
Joined: Sun Mar 09, 2008 3:07 pm
Location: cheshire , england
Great Britain

#2

Post by christopher storey » Sun Apr 20, 2014 6:43 am

My opinion is - you are well overdue for new plugs !

Link:
BBcode:
HTML:
Hide post links
Show post links

User avatar

Topic author
abowie
Posts: 4149
Joined: Wed Sep 07, 2011 9:15 pm
Location: Australia
Australia

#3

Post by abowie » Sun Apr 20, 2014 7:59 am

christopher storey wrote:My opinion is - you are well overdue for new plugs !
They're about 12 months old and have covered about 600 miles.

Do you think they're lean, rich, about right?
Andrew.
881824, 1E21538. 889457. 1961 4.3l Mk2. 1975 XJS. 1979 MGB (supercharged).
Adelaide, Australia

Link:
BBcode:
HTML:
Hide post links
Show post links


christopher storey
Posts: 5698
Joined: Sun Mar 09, 2008 3:07 pm
Location: cheshire , england
Great Britain

#4

Post by christopher storey » Sun Apr 20, 2014 8:13 am

Well, I was actually being serious. These plugs - look at the bodies and the washers - are in quite a state for such a low usage . Maybe it is an aberration caused by the lens, but the plug on the left appears to have a centre electrode which is eroded on the right hand side, and the centre plug is the same with in addition some erosion of the outer electrode . The gaps also look very wide , even if you are running electronic ignition . As far as colour is concerned, with modern unleaded fuels it is very difficult to deduce anything from them unless they are either very weak ( blistered ceramics etc ) or very rich ( everything sooty ) . Also, a plug chop has to be done by shutting off immediately after a full throttle run of several seconds . Going home after a run and then pulling the plugs will not really tell you anything

Link:
BBcode:
HTML:
Hide post links
Show post links

User avatar

Topic author
abowie
Posts: 4149
Joined: Wed Sep 07, 2011 9:15 pm
Location: Australia
Australia

#5

Post by abowie » Sun Apr 20, 2014 9:51 am

christopher storey wrote: Also, a plug chop has to be done by shutting off immediately after a full throttle
Yep that's how I do it too. I agree, the gaps are set wide as I have an EDIS unit on the car.

Any one have any comments on the tune state? Are the front 2 too lean or is the back one too rich?
Andrew.
881824, 1E21538. 889457. 1961 4.3l Mk2. 1975 XJS. 1979 MGB (supercharged).
Adelaide, Australia

Link:
BBcode:
HTML:
Hide post links
Show post links

User avatar

Heuer
Administrator
Posts: 15198
Joined: Sat Mar 01, 2008 5:29 pm
Location: Nottinghamshire
Great Britain

#6

Post by Heuer » Sun Apr 20, 2014 10:20 am

After a lot of trial and error with the EDIS I set the gaps at .030". Anything larger produced no appreciable difference in performance and I could not be sure it would cause problems under high load/poor fuel/altitude etc. For the cost I would swap the plugs anyway and avoid anything involving rare earth metals :roll:
David Jones
S1 OTS OSB
1997 Porsche 911 Guards Red
2024 Lexus LBX

Add your E-Type to our World Map: http://forum.etypeuk.com/viewtopic.php?f=1&t=1810

Link:
BBcode:
HTML:
Hide post links
Show post links

Post Reply Previous topicNext topic