Series 1 2+2 trim b posts bd28902 /3

[Spark]

Does anyone have or know where I can secure the two trim pieces
Can't locate them anywhere
Heading to Stonleigh next week to scavenge the stands
Any help please

Thanks

[mgcjag]

Hi Sparks....try CMC....they now also sell used parts......just re trimmed mine...they would not be too difficult to make with thin aluminium..also try the trimmers.....Aldridge, Skinners, BAS

[Spark]

Hi
Thanks have tried CMC
Need to try the trimmers
Does anyone have a picture or profile of the part , as I could fabricate from aluminium plate

Thanks
Phil

[mgcjag]

Hi Phil.....these are the best i can do..just retrimmed and refitted mine so dont really want to pull then off again......but if you know someone that has a E they just pull off you can see the retaining trim clips in the photo about 2in in from each end

[Spark]

Hi
Thanks the pic early help
Does anyone have a profile pic

Thanks

[mgcjag]

Hi Spark.....done a quick sketch.....measuements are very approx as mine is now trimmed and fitted the top and bottom dont have the full profile as the top fits into the cant rail....are you going to Stonleigh tomorrow, if not do you want me to look out for a pair....PM me ..Steve

[Spark]

Hi Steve
Thanks for the guide think I can make some up with you pics and photos
Thanks again
Didn't get to Stoneligh today, thanks for the kind offer

Cheers
Phil

[Spark]

Hi
Thanks for the feedback
CMC don't have any, I have some Ali plate and will need to make some
Still looking for originals if any about in any condition

Thanks