Is there a chrome bit on this piece of trim?

[ChrisC]

Chaps,

I wonder if one of you helpful people wouldnt mind popping into their garage and looking at their FHC for me... Preferably someone with a 3.8...

In the picture below I am test fitting the trim before its put into place and it *looks* to me that the end of the (not sure what its called) top piece of trim might have a chrome finisher at the front (or it might not).

As any kind of finisher cant be mounted AFTER i fit this piece of trim - I would like to know if I have to go searching for a piece of chrome.

A picture of the missing item(s) would be fantastic!!! :)

thanks all

[christopher storey]

Yes,IIRC there should be a half moon shaped chrome finisher which sits vertically on the front of the roll, and corresponds to the shape of the roll. A tongue to secure it to the back of the roll slides into that gap which you can see in your photo

[vipergts]

Yes indeed and it disguises the end of that chrome strip too

[ChrisC]

Darn...

Can someone take a photo please?

I will need to rumage about in a load of boxes of old bits now :( because i am pretty sure I havnt re-chromed anything like that.

Using my photo as the reference - is it a sort of D shape when looking at the vinyl trim end on...

Another hold up

[christopher storey]

Yes, a D shape describes it perfectly

[Series 1]

[ChrisC]

Aha! and Damn....

Aha : thanks for the picture, at least i know what I am looking for now....

Damn: I have no idea where those pieces are :(

I also see that there is a another piece of trim I am missing - the wrap-around-the-edge-strip just below the chrome...

Ho Hum...

Thanks all