hesitation at 1500 to 2250

Technical advice Q&A

Topic author
adam
Posts: 272
Joined: Mon Sep 01, 2008 9:11 pm
Great Britain

#1 hesitation at 1500 to 2250

Post by adam » Wed Apr 12, 2017 4:53 pm

I have a hesitation when my car pulls between 1500 and 2250 revs, occasionally. My car is a 3.8 with a 123 distributor and standard air filter. I have replaced plugs NGK BP5ES dizzy cap & rotor arm both of which were black and pitted, leads also replaced. 123 distributor has been fitted for over nine years no problems, until a week ago there was no hesitation/cough, any ideas?

Thanks Adam

Link:
BBcode:
HTML:
Hide post links
Show post links

User avatar

Tbob
Posts: 172
Joined: Mon Aug 10, 2015 1:44 pm
Location: Kenton co, ky
United States of America

#2 Re: hesitation at 1500 to 2250

Post by Tbob » Wed Apr 12, 2017 6:34 pm

I had the wrong gap on my spark plugs, which caused me the same symptom. Went from .035 to .025 and it purrs now.
Bob t

LHD '69 OTS. (Former) basket case

Link:
BBcode:
HTML:
Hide post links
Show post links


Topic author
adam
Posts: 272
Joined: Mon Sep 01, 2008 9:11 pm
Great Britain

#3 Re: hesitation at 1500 to 2250

Post by adam » Wed Apr 12, 2017 7:01 pm

Thanks for the reply,I set the plugs to 25 thou and also checked fuel filter, clean as a whistle.

Adam

Link:
BBcode:
HTML:
Hide post links
Show post links

User avatar

mgcjag
Moderator
Posts: 9210
Joined: Fri Jul 09, 2010 6:15 pm
Location: Ludlow Shropshire
Great Britain

#4 Re: hesitation at 1500 to 2250

Post by mgcjag » Wed Apr 12, 2017 7:09 pm

Hi Adam...if everything was black and pitted it sounds like its been a bit neglected....not sure if your saying it hasnt been serviced for 9 years but the carbs could probably do with an overhaul...also just check out all tne low tension wireing could just be a loose wire .....end of the day its electrics or fuel
Steve
69 S2 2+2 (sold) ..Realm C type replica, 1960 xk150fhc

Link:
BBcode:
HTML:
Hide post links
Show post links


Topic author
adam
Posts: 272
Joined: Mon Sep 01, 2008 9:11 pm
Great Britain

#5 Re: hesitation at 1500 to 2250

Post by adam » Wed Apr 12, 2017 7:27 pm

Hi, its serviced every year, 123 distributor only needs cap and rotor arm replacing every 40000 km. Carbs rebuilt in the last 15000 miles, tried using choke to see if it made difference to hesitation no difference.

Adam

Link:
BBcode:
HTML:
Hide post links
Show post links

User avatar

mgcjag
Moderator
Posts: 9210
Joined: Fri Jul 09, 2010 6:15 pm
Location: Ludlow Shropshire
Great Britain

#6 Re: hesitation at 1500 to 2250

Post by mgcjag » Wed Apr 12, 2017 8:01 pm

Check out the coil
Steve
69 S2 2+2 (sold) ..Realm C type replica, 1960 xk150fhc

Link:
BBcode:
HTML:
Hide post links
Show post links

Post Reply Previous topicNext topic